|
Q.
Is the check result normal?
Go to Step 2 .
Repair or replace the connector.
|
|
- Check the A/C compressor solenoid valve itself (Refer to Group 55B - Compressor
Assembly - Inspection .
|
|
Q.
Is the check result normal?
|
|
Repair the A/C compressor solenoid valve.
|
|
|
|
- Disconnect connector, and measure at harness side.
- Ignition switch: ON
- Voltage between terminal No. 1 and earth.
OK: System voltage
Q.
Is the check result normal?
Go to Step 5 .
Go to Step 4 .
|
|
Q.
Is the check result normal?
Check intermediate connector A-36 and B-212,
and repair if necessary. If intermediate connector is normal, check and repair harness between
A-124 (terminal No. 1) A/C compressor connector and B-206 (terminal No. 4) engine control relay connector.
- Check power supply line for open/short circuit.
Repair or replace the connector.
|
|
- Disconnect connector, and measure at harness side.
- Ignition switch: ON
- Voltage between terminal No. 39 and earth.
OK: System voltage
Q.
Is the check result normal?
Go to Step 6 .
Check and repair harness between A-124 (terminal No.
2) A/C compressor connector and A/C compressor connector and A-34 (terminal No. 39) engine-ECU
connector.
- Check earthing line for open/short circuit.
|
|
Q.
Is the check result normal?
Go to Step 7 .
Repair or replace the connector.
|
|
- Check earthing line for damage.
Q.
Is the check result normal?
Go to Step 8 .
Repair the damaged harness wire.
|
|
- Check power supply line for damage.
Q.
Is the check result normal?
Replace the engine-ECU then perform the variant coding (Refer to GROUP 00 - Precautions
Before Service - How to Perform Coding
Repair the damaged harness wire.
|