MSB is released for this page as follows:
Release DateSubjectMSB No.
2008-06-20REMOVAL SERVICE POINT OF GEARSHIFT CABLE/SELECT CABLE CONNECTIONMSB-08E22-002

REMOVAL AND INSTALLATION







Gearshift lever assembly removal steps


1.
Gearshift lever knob


·
Floor console front bracket (Refer to GROUP 52A ).


·
Rear heater duct (Refer to GROUP 55A ).


2.
Harness


3.
Shift lever assembly mounting bolt


4.
Grommet mounting nut
<<A>>

5.
Gearshift cable connection (Gearshift lever side)
<<A>>

6.
Select cable connection (Gearshift lever side)


7.
Gear shift lever assembly



Gearshift cable and select cable assembly removal steps


·
Air intake hose (Refer to GROUP 15 <134, 135>, <4G1>, <639>).


·
Battery and battery tray
<<B>>

8.
Gearshift cable connection (Transmission side)
<<B>>

9.
Select cable connection (Transmission side)


·
Front exhaust pipe (Refer to GROUP 15 <134, 135>, <4G1>, <639>).


·
Heat protector


10.
Gearshift cable and select cable assembly

REMOVAL SERVICE POINTS



<<A>> GEARSHIFT CABLE AND SELECT CABLE (GEARSHIFT LEVER SIDE) DISCONNECTION



1.Disconnect the gearshift lever assembly from the ends of the gearshift and select cables.

2.
caution Be careful not to damage the connection of the gearshift and select cables when disconnecting them. Do not reuse gearshift and select cables, if they are damaged.
Release the gearshift and select cables from the gearshift lever assembly-side cable brackets by compressing their locks with a flat-tipped screwdriver.

<<B>> GEARSHIFT CABLE AND SELECT CABLE (TRANSMISSION SIDE) DISCONNECTION



1.Disconnect the transmission assembly-transmission lever from the ends of the gearshift and select cables.

2.
caution Be careful not to damage the connection of the gearshift and select cables when disconnecting them. Do not reuse gearshift and select cables, if they are damaged.
Release the gearshift and select cables from the transmission-side cable brackets by compressing their locks with a flat-tipped screwdriver.





Yandex.Metrika
MMC-Manuals.ru