|
Check the battery and charging system.
|
|
- Ignition switch: ON
- Engine: Start
- Engine speed: Approximately 2500 rpm
|
|
Measure the voltage between the battery terminals.
|
|
Q.
Is the check result normal?
|
|
Inspection, repair or replace the charging system component(s).
|
|
|
|
caution |
Before connecting or disconnecting the M.U.T.-III, turn the ignition switch to the "LOCK"
(OFF) position.
|
Check again if the diagnosis code is set. (1)Turn the ignition switch to the "ON" position. (2)Erase the diagnosis code. (3)Turn the ignition switch to the "LOCK" (OFF) position. (4)Turn the ignition switch to the "ON" position. (5)Check if the diagnosis code is set. (6)Turn the ignition switch to the "LOCK" (OFF) position. (7)Disconnect M.U.T.-III.
Q.
Is code No.C1860 set?
Replace the hydraulic unit (integrated with ABS-ECU) (Refer to ).
The malfunction is intermittent. Refer to GROUP 00, How to Use Troubleshooting/Inspection
Service Points - How to Cope with Intermittent Malfunction .
|