WINDSHIELD INTERMITTENT WIPER INSPECTION



  1. Check that the wipers operate in the intermittent action when the windshield intermittent wiper switch is at the intermittent position.
  2. Check that the intermittent wiper interval is changed as the intermittent wiper volume is operated.
  3. Turn the windshield intermittent wiper switch to the intermittent operation position. Use the M.U.T.-III to set a simulated vehicle speed with the wiper volume held. The intermittent wiper interval should be changed as the simulated vehicle speed is changed.
  4. If either of the above is defective, carry out the troubleshooting. For troubleshooting, refer to GROUP 54B, Troubleshooting .





Yandex.Metrika
MMC-Manuals.ru