;
2018 / ECLIPSE CROSS / EC - Workshop Manual
33 -FRONT SUSPENSION > STRUT ASSEMBLY > STRUT ASSEMBLY REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
caution
  • The parts indicated by *1 indicates parts which should be temporarily tightened, and then fully tightened with the vehicle standing on the ground at curb weight.
  • The parts indicated by *2 are the nuts with friction coefficient stabilizer. Prior to reinstallation, ensure there is no damage, clean dust and soiling from the bearing and thread surfaces, and tighten them to the specified torque.
Pre-removal Operation
  • Front Height Sensor Removal (Refer to GROUP 54A - Height Sensor ). <Vehicles with headlamp automatic levelling system>
Post-installation Operation
  • Front Height Sensor Installation (Refer to GROUP 54A - Height Sensor ). <Vehicles with headlamp automatic levelling system>
  • Front Wheel Alignment Check and Adjustment (Refer to ).
 
Removal steps
1.Front height sensor and lower arm connecting nut <Vehicles with headlamp automatic levelling system>
2.Brake hose bracket
<<A>>>>A<<3.Stabilizer link and strut connection nut
4.Knuckle and strut connection
5.Strut mounting nut
6.Front suspension strut stiffener plate
7.Strut assembly
 
 
REMOVAL SERVICE POINT
 
 
<<A>> STABILIZER LINK AND STRUT CONNECTION NUT REMOVAL
 
Use a hexagon wrench to counterhold the stabilizer link as shown. Then use a wrench to remove the nut securing the stabilizer link to the strut.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< STABILIZER LINK AND STRUT CONNECTION NUT INSTALLATION
 
Use a hexagon wrench to counterhold the stabilizer link as shown. Then use a wrench to install the nut securing the stabilizer link to the strut.
 
 




Yandex.Metrika
MMC-Manuals.ru