REMOVAL AND INSTALLATION



caution
  • After the installation of shift position switch, be sure to adjust the shift position switch (refer to ).
Pre-removal and post-installation operation
  • Transmission control cable (transmission side) removal and installation (Refer to .)





Shift position switch (main) removal


1.
Rod assembly


2.
Control lever (main)


3.
Shift position switch (main)



Shift position switch (sub) removal


1.
Rod assembly
<<A>>
>>A<<
4.
Control lever (sub)


5.
Shift position switch (sub)

REMOVAL SERVICE POINTS



<<A>> CONTROL LEVER (SUB) REMOVAL


caution To prevent any damage from occurring to the shift position switch, be sure to counterhold the lever.

Use an open-end wrench to hold the control lever (sub), and remove the mounting nut.

INSTALLATION SERVICE POINTS



>>A<< CONTROL LEVER (SUB) INSTALLATION


caution To prevent any damage from occurring to the shift position switch, be sure to counterhold the lever.

Use an open end wrench to hold the control lever (sub), and tighten the mounting nut to the specified torque.
Tightening torque: 22 ± 3 N·m




Yandex.Metrika
MMC-Manuals.ru