MSB is released for this page as follows:

Release Date	Subject	MSB No.
2016-08-30	Errors in writing of the descriptions regarding the heater,air conditioner and ventilation	MSB-16EXL55-502

REMOVAL AND INSTALLATION

Pre-removal and Post-installation Operation

Refrigerant draining and refilling (Refer to ).
Radiator grille assembly removal and installation (Refer to GROUP 51 - Radiator grille )
Cooling fan and cooling fan clutch assembly removal and installation (Refer to GROUP 14 - Radiator fan <4G6>, <4D5>, <4N1>)
Radiator shroud assembly removal and installation (Refer to GROUP 14 - Radiator )

		A/C condenser fan removal steps <Vehicles with condenser fan>
	1.	A/C condenser fan motor and shroud
	2.	A/C condenser grille
	3.	A/C condenser fan
	4.	A/C condenser fan motor
	5.	A/C condenser fan shroud
	6.	A/C condenser bushing
		A/C condenser removal steps
<<A>>	7.	A/C condenser outlet pipe B connection
<<A>>	8.	A/C compressor discharge hose connection
<<B>>	9.	A/C condenser assembly
	10.	A/C condenser clamp
	11.	A/C condenser insulator <2WD>
	12.	A/C condenser insulator <4WD>
	13.	A/C condenser bracket
	14.	O-ring
	15.	A/C receiver assembly

REMOVAL SERVICE POINTS

caution

Use the plug which is not breathable because A/C compressor oil or receiver have high hygroscopicity.

Plug the removed nipple of the pipe, hose to prevent the entry of dust and dirt.

Tilt the A/C condenser assembly towards the engine compartment, and then lift out it.