Mitsubishi Motors Service Manual

2020 / OUTLANDER / EU - Workshop Manual

54 -CHASSIS ELECTRICAL > 54A-CHASSIS ELECTRICAL > SMARTPHONE-LINK DISPLAY AUDIO (SDA) > SYMPTOM PROCEDURES > The hands-free cellular phone system does not operate correctly.

Inspection Procedure 9: The hands-free cellular phone system does not operate normally.

caution

Before replacing the multivision display, ensure that the power supply circuit, the earth circuit and the communication circuit are normal.

COMMENTS ON TROUBLE SYMPTOM

If a hands-free cellular phone system does not function correctly, a Bluetooth^® device is not paired or the multivision display may be defective.

PROBABLE CAUSES

Malfunction of multivision display
Pairing with the Bluetooth^® device has not been completed.
The Bluetooth^® device is not supported.

DIAGNOSIS PROCEDURE

STEP 1. Check whether the Bluetooth^® device is supported.

Check whether the Bluetooth^® device is supported.

note	Supported Bluetooth^® devices are listed on the MITSUBISHI MOTORS web site.

Is the check result normal?

Go to Step 2.

Use the supported Bluetooth^® device.

STEP 2. Reset the multivision display and check the trouble symptom.

(1)

caution

If the multivision display is reset, all the data stored by customer will disappear. Therefore, prior to the reset, the agreement of the customer should be obtained.
If the multivision display is reset, the guide line for the rear view camera will be initialised. In that case, readjust the guide line.

Reset the multivision display. (Refer to

(2) Carry out the necessary pairing for the Bluetooth^® device. (Refer to

(3) Check whether the hands-free cellular phone system works normally.

Is the check result normal?

The diagnosis is complete.

Replace the multivision display (Refer to