CUSTOMISATION FUNCTION


By operating the M.U.T.-III ETACS system or MMCS, the following functions can be customised. The programmed information is held even when the battery is disconnected.
Adjustment item (M.U.T.-III display)
Adjustment item
Adjusting content (M.U.T.-III display)
Adjusting content
ACC power auto cut
Time to ACC power cut-off when the ignition switch is in the ACC position
Disable
No function
30 min
30 minutes (initial condition)
60 min
60 minutes
Turn power source
Adjustment of turn-signal lamp operation condition
ACC or IG1
Operable with ACC or ON position
IG1
Operable with ON position (initial condition)
Comfort flasher
With/without comfort flasher function
Disable
No function
Enable
With function (initial condition)
Comfort flasher switch time
Switch operation time to activate the comfort flasher function
Normal
0.4 second (initial condition)
Long
0.8 second
Hazard answer back
Adjustment of the number of keyless hazard warning lamp answer back flashes
Lock:1, Unlock:2
LOCK: Flashes once, UNLOCK: Flashes twice (initial condition)
Lock:1, Unlock:0
LOCK: Flashes once, UNLOCK: No flash
Lock:0, Unlock:2
LOCK: No flash, UNLOCK: Flash twice
Lock:2, Unlock:1
LOCK: Flash twice, UNLOCK: Flash once
Lock:2, Unlock:0
LOCK: Flash twice, UNLOCK: No flash
Lock:0, Unlock:1
LOCK: No flash, UNLOCK: Flash once
Lock:0, Unlock:0
No function
Front wiper operation
Adjustment of the intermittent windshield wiper operation <vehicles without lighting control sensor>
Normal INT
Intermittent wiper interval is fixed to 4 seconds.
Variable INT
Intermittent wiper interval is calculated only by the wiper volume control.
Speed Sensitive
Intermittent wiper interval is calculated according to the intermittent wiper volume control and vehicle speed (initial condition).
Adjustment of the intermittent windshield wiper operation <vehicles with lighting control sensor>
Normal INT
Intermittent wiper interval is fixed to 4 seconds.
Variable INT
Intermittent wiper interval is calculated only by the wiper volume control.
Speed Sensitive
Intermittent wiper interval is calculated according to the intermittent wiper volume control and vehicle speed.
Rain Sensitive
Intermittent wiper interval is calculated according to the intermittent wiper volume control and lighting control sensor (initial condition).
Front wiper washer
Disabling or enabling washer-linked wiper function
Only Washer
No function
Washer & Wiper
With function: Without delayed finishing wipe function <Initial condition (vehicles for RUSSIA)>
With after wipe
With function: With delayed finishing wipe function <Initial condition (except vehicles for RUSSIA)>
Intelligent/Comfort washer
With/without Comfort washer function
Disable
No function <Initial condition (vehicles for RUSSIA)>
Enable
With function <Initial condition (except vehicles for RUSSIA)>
Intermittent time of rear wiper
Adjustment of rear wiper interval
0 sec
No wiper interval
4 sec
4 seconds
8 sec
8 seconds (initial condition)
16 sec
16 seconds
Rear wiper low speed mode
Disabling or enabling rear wiper continuous operation
Disabled
No function
Enabled
With function (initial condition)
Rear wiper(linked reverse gear)
Adjustment of automatic rear window wiper operation with reverse gear engaged
Enable(R wip.ON)
Operates only when the rear wiper switch is ON.
Enable(R/F wip.)
Operates only when the front or rear wiper switch is ON (initial condition).
Auto fold mirror
Electric folding door mirror automatic unfolding function
Not Auto
No synchronised operation
Open Vehicle SPD
Vehicle speed-dependent operation
Open/Close by IG
Ignition switch linked operation
OPN/CLS Keyles
Keyless entry linked operation (initial condition)
Sensitivity for auto lamp
Photo sensor sensitivity (illumination intensity) <vehicles without lighting control sensor>
Level 1 bright
High ambient brightness
Level 2 bright
Standard ambient brightness (initial condition)
Level 3
Low ambient brightness
Level 4 dark
Low-low ambient brightness
Lighting control sensor sensitivity (illumination intensity) <vehicles with lighting control sensor>
Level 1 bright
High-high ambient brightness
Level 2 bright
High ambient brightness
Level 3
Standard ambient brightness (initial condition)
Level 4 dark
Low ambient brightness
Level 5 dark
Low-low ambient brightness
Auto lamp linked wiper
Presence of wiper-linked auto lamp function <vehicles without lighting control sensor>
Disable
No function (initial condition)
Enable
With function
Welcome light
Disabling or enabling welcome light function
Disabled
No function
Small lamp
The tail lamps illuminate. (initial condition)
Head lamp
The headlamps illuminate.
Coming home light
Disabling or enabling coming home light function
Disabled
No function
15 sec
The headlamps illuminate for 15 seconds.
30 sec.
The headlamps illuminate for 30 seconds. (initial condition)
60 sec
The headlamps illuminate for 60 seconds.
180 sec
The headlamps illuminate for 180 seconds.
Room lamp delay timer with door
Adjustment of interior lamp delay shutdown time
0 sec
0 second (no delay shutdown time)
7.5 sec
7.5 seconds
15 sec
15 seconds (initial condition)
30 sec
30 seconds
60 sec
60 seconds
120 sec
120 seconds
180 sec
180 seconds
Head lamp auto cut customise
Adjustment of headlamp automatic shutdown function
Disable
No function
Enable (B-spec.)
With function (initial condition)
Interior lamp auto cut timer
Adjustment of interior lamp automatic shutdown function operation time
Disable
No function
3 min
3 minutes
30 min
30 minutes (initial condition)
60 min
60 minutes
Door unlock mode
Adjustment of power door locks with selective unlocking
All Doors Unlock
Without function: The first operation of keyless entry system or unlock operation by KOS unlocks all doors (initial condition).
Dr Door Unlock
With function: The first operation of keyless entry system or unlock operation by KOS unlocks the driver’s door only, and the second unlock operation within 2 seconds after that unlocks all doors.
Auto door unlock
Adjustment of the auto door unlock function
Disabled
Without function <M/T, CVT, TC-SST> (initial condition)
Always (P pos)
With function: Operates when the shift lever or the selector lever is moved to the P position. <CVT, TC-SST>
Always(Lock pos)
With function: Operates when the ignition switch is moved to the LOCK (OFF) position. <M/T, CVT, TC-SST>
Timer lock timer
Timer lock period adjustment
30 sec
30 seconds (initial condition)
60 sec
60 seconds
120 sec
120 seconds
180 sec
180 seconds
Sensitivity for security sensor
Sensitivity level setting of security alarm sensor <Vehicles with security alarm>
Level 1
100% sensitivity of security alarm sensor (initial condition)
Level 2
90% sensitivity of security alarm sensor
Level 3
80% sensitivity of security alarm sensor
Level 4
70% sensitivity of security alarm sensor
Alarm
Enables/disables security alarm <Vehicles with security alarm>
Disable
Without function
Enable
With function (Initial condition)
Multi mode
Multi-mode keyless entry function customisation <Vehicles with electric retractable remote controlled door mirrors>
Disable
No function
D/M: O&C
Door mirror fold/unfold operation only (initial condition)
KOS key detect out from window
With/without KOS key exterior detection function
Disable
No function (initial condition)
Enable
With function
KOS feature
KOS function adjustment
Both enable
All KOS functions are enabled (initial condition).
Door Entry enable
Only door entry function is enabled.
ENG strt enable
Only engine starting function is enabled.
Both disabled
All KOS functions are disabled.





Yandex.Metrika
MMC-Manuals.ru