|
1.Start the engine and allow it to warm up until the temperature of the engine coolant
reaches 80 °C to 90 °C.
|
|
2.Remove the engine oil filler cap.
|
|
3.Remove the under skid plate and engine room under cover front (Refer to GROUP 51 -
Under
Cover ).
|
|
4.
warning |
Use care as engine oil could be hot.
|
Remove the engine oil pan drain plug to drain engine oil.
|
|
5.Install a new engine oil pan drain plug gasket, and then tighten the engine oil pan drain
plug to the specified torque. Tightening torque: 39 ±
5 N·m 6.Install the under skid plate and engine room under cover front (Refer to GROUP 51 -
Under
Cover ).
|
|
7.Refill with specified quantity of engine oil. Specified Engine Oil
- ACEA classification: "For service A1/B1, A3/B3, A3/B4 or A5/B5"
- ILSAC classification: ILSAC certificated oil
- API classification: "For service SG or higher"
Total quantity (Includes volume inside engine oil filter): 4.3 L
note |
Select engine oil of the proper SAE viscosity number according to the atmospheric temperature. SAE 0W-30, 5W-30, and 5W-40 engine oils can only be used if they meet ACEA A3/B3, A3/B4
or A5/B5 and API SG (or higher) specification.
|
8.Install the engine oil filler cap. 9.Check engine oil level.
|
|
1.Start the engine and allow it to warm up until the temperature of the coolant reaches
80 °C to 90 °C.
|
|
2.Remove the oil filler cap.
|
|
3.Remove the under skid plate and engine room under cover front (Refer to GROUP 51 -
Under
Cover ).
|
|
4.
warning |
Use care as oil could be hot.
|
Remove the oil drain plug to drain oil.
|
|
5.Install a new oil drain plug gasket, and then tighten the drain plug to the specified
torque. Tightening torque: 39 ±
5 N·m 6.Install the under skid plate and engine room under cover front (Refer to GROUP 51 -
Under
Cover ).
|
|
7.Refill with specified quantity of oil. Specified Engine Oil
- ACEA classification: "For service A1/B1, A3/B3, A3/B4 or A5/B5"
- API classification: "For service CD or higher"
Total quantity (Includes volume inside oil filter and oil cooler): 7.4L
note |
Select engine oil of the proper SAE viscosity number according to the atmospheric temperature.
|
8.Install the oil filler cap. 9.Check oil level.
|