FUEL LINE LEAK CHECK


1.Connect the M.U.T.-III to the diagnosis connector.
2.Start the engine, and let it run at idle.
3.Select "MPI/GDI/DIESEL" from System select Screen of the M.U.T.-III.
4.Select "Special Function" from MPI/GDI/DIESEL Screen.
5.Select "Fuel leakage check" from Test Screen. Carry out the fuel leakage check five times in a row.
note During the test, the engine speed and the fuel pressure is 2, 000 r/min and 180Mpa for 20 seconds respectively.
6.Turn the ignition switch to the "LOCK" (OFF) position, and stop the engine.
7.Disconnecting the M.U.T.-III is the reverse of the connecting sequence.





Yandex.Metrika
MMC-Manuals.ru