|
1.Remove the pad assembly, pad and wear indicator assembly, shim, shim cover <16
inch> and clip (Refer to ).
|
|
2.Using a spring scale, measure the hub sliding torque in the forward direction with the
pad assembly, pad and wear indicator assembly, shim, shim cover <16 inch> and
clip removed. 3.Install the pad assembly, pad and wear indicator assembly, shim, shim cover <16
inch> and clip (Refer to ). 4.Start the engine, and depress the brake pedal lightly two or three times. Then stop
the engine. (Depressing force: approximately 50 - 100 N) 5.Turn the brake disc 10 times in the forward direction. 6.Using a spring scale, measure the hub sliding torque in the forward direction with
the pad assembly, pad and wear indicator assembly, shim, shim cover and clip installed. 7.Obtain the disc brake drag force (difference between measured values of item 2 and
item 6). Standard value: 95 N or less <16 inch>, 56 N or less <17 inch> 8.If the brake drag force exceeds the standard value, disassemble the front brake assembly
to check for fouling/rust on the piston sliding section, piston seal and piston boot deterioration,
and confirm whether the pin slide properly (Refer to <16
inch>, <17 inch>).
|