REMOVAL AND INSTALLATION



Pre-removal and post-installation operation
  • Quarter upper trim removal and installation (Refer to GROUP 52A - Interior Trim ).






Removal steps
<<A>>
>>B<<
1.
Quarter window glass assembly

>>A<<
2.
Clip

>>A<<
3.
Fastener


4.
Quarter window glass

REMOVAL SERVICE POINTS



<<A>> QUARTER WINDOW GLASS ASSEMBLY REMOVAL


Only some removal service points are described here. For the other removal service points, refer to "WINDOW GLASS" section.
1.Stick the protective tapes to avoid the quarter window glass assembly from dropping.
2.Using glass adhesive knife

3.Working inside the vehicle, insert the tip of a windshield knife into the sealed part of the quarter window glass assembly.
4.
caution If you lever the windshield knife, the quarter window glass assembly may be damaged.
Holding the tip of the glass adhesive knife and the body flange at right angles, align the blade of the windshield knife with the body flange, and pull the blade parallel to the body flange to separate the adhesive.

5.Use a piano wire to separate the clips.

INSTALLATION SERVICE POINTS



>>A<< FASTENER/CLIP INSTALLATION



1.If the quarter window glass assembly is reused, follow the procedures below:
(1) Engage the clip with the body.
(2) Cut off the convex portion of the quarter window glass assembly clip installation position.
note If the quarter window glass assembly is installed without cutting off the convex portion of the quarter window glass assembly clip installation position, improper installation may result.
2.
caution Before the next operation, leave the decreased parts for 3 minutes or more to dry. Do not touch the degreased parts.
Use parts cleaner (MZ100387 or equivalent) to degrease the inside circumference of the quarter window glass assembly and the body flanges.

3.Install the fasteners to the specified positions on the body flange.
4.Install the fasteners to the quarter window glass assembly at the positions which correspond to the fasteners on the body flange.

>>B<< QUARTER WINDOW GLASS ASSEMBLY INSTALLATION


1.Apply the primer and adhesive.
2.Install the quarter window glass assembly by the same procedures as for the windshield glass (Refer to ).





Yandex.Metrika
MMC-Manuals.ru