Section
|
Basic contents
|
Component locations
|
Locations are shown for each point of relays, ECUs, sensors, solenoid
valves, inspection connectors, fusible links, fuses, etc. In the part’s lists, parts
are listed in alphabetical order.
|
Configuration diagrams
|
Connector locations and harness wiring configurations on actual vehicles
are illustrated. Especially, high-voltage wires (330 V) are described separately from low-voltage
wires (12 V).
|
Circuit diagrams
|
Circuits from power source to earth are shown completely, classified
according to system. There is a main division into power source circuits and circuits classified
by system.
- Junction block
The entire circuit for the junction block is described, because only the part of the junction
block needed is normally shown in each circuit diagram.
- Joint connectors
The internal circuits for all joint connectors are described, because only the part needed
is shown in each circuit diagram.
- Power source circuits
Low-voltage power source circuits (12 V) from auxiliary battery to fusible links, fuses
and the electric motor switch are described. High-voltage power source circuits (330 V) are
described in high-voltage power source control circuits of circuits classified by system.
- Circuits classified by system
For each system, the circuits are shown from fuse to earth, excluding the power source
sections.
|
