MSB is released for this page as follows:

Release Date	Subject	MSB No.
2013-10-10	Power switch operation at the time of the M.U.T.-III communication	MSB-13EXML00-003

OPTION CODING

caution

If there is any item indicated by the option coding after equipment change, set ETACS-ECU so that the option coding data corresponds with the equipment content. Pay attention to that the concerned functions and systems do not work normally if the setting does not correspond with the equipment.

The ETACS-ECU option coding data can be checked or changed by operating M.U.T.-III.

HOW TO CHECK OPTION CODING DATA

1.Ensure that the electric motor switch is at the "LOCK" (OFF) position.
2.Start up the personal computer.
3.Connect special tool M.U.T.-III USB cable (MB991827) to Vehicle Communication Interface (V.C.I.) (MB991824) and the personal computer.
4.Connect M.U.T.-III main harness A (MB991910) to the V.C.I.
5.Connect the M.U.T.-III main harness A to the diagnosis connector.
6.Turn the V.C.I. electric motor switch to the "ON" position.

note

When the V.C.I. is energized, the V.C.I. indicator lamp will be illuminated in a green colour.

7.Start the M.U.T.-III system on the personal computer and turn the electric motor switch to the "ON" position.
8.Select "ETACS" on the system selection screen.
9.Select "Coding."
10.Select "Option Coding Information."
11.Check the displayed option coding information.

HOW TO CHANGE OPTION CODING

1.Connect the M.U.T.-III.

2.Select "ETACS" on the system selection screen.

3.Select "Coding."

4.Select "Option Coding."

5.Change to correct option coding data.

LIST

Item name	Value
Front fog lamp	Not present or Present

MMC-Manuals.ru