PROCEDURE FOR MAIN BATTERY ACCEPTANCE JUDGMENT

INSPECTION PROCEDURE

If any abnormality is found after following inspections, replace the main battery.
1.Check of whether or not diagnosis code is set
2.Check of battery tray cracking and double frame (crossmember and battery tray bracket) cracking/flaw
3.Relative deformation measurement of double frame (crossmember) and body joining
4.Relative deformation measurement of double frame (battery tray bracket) and battery tray

RELATIVE DEFORMATION MEASUREMENT OF DOUBLE FRAME (CROSSMEMBER) AND MAIN BODY JOINING

Perform the measurement with using the tracking gauge, convex, or others. The indicated numbers are provided for a reference.

Number	Measurement reference point
1	Battery tray cross bracket front assembly leading end corner (LH)
2	Battery tray cross bracket front assembly leading end corner (RH)
3	Battery tray (A) crossmember assembly leading end corner
4	Battery tray (B) crossmember assembly leading end corner
5	Battery tray (C) crossmember assembly leading end corner
6	Battery tray (D) crossmember assembly leading end corner

PROCEDURE FOR RELATIVE DEFORMATION MEASUREMENT OF DOUBLE FRAME (BATTERY TRAY BRACKET) AND BATTERY TRAY

Using the thickness gauge, measure the clearance between the battery tray and the battery tray bracket.
Standard value: 3.9mm or less

MMC-Manuals.ru