MSB is released for this page as follows:

Release Date	Subject	MSB No.
2010-11-20	MAIN AND AUXILIARY BATTERIES SERVICE PROCEDURES	MSB-10E00-018
2011-06-20	MAIN AND AUXILIARY BATTERIES SERVICE PROCEDURES	MSB-11E00-004
2013-10-10	Power switch operation at the time of the M.U.T.-III communication	MSB-13EXML00-003
2014-09-15	RESET ESTIMATED INFORMATION AND CONTROL INFORMATION OF DRIVE BATTERY CAPACITY	MSB-14EXML00_54-001
2014-11-24	RESET ESTIMATED INFORMATION AND CONTROL INFORMATIN OF DRIVE BATTERY CAPACITY	MSB-14EXML00_54-001B
2015-10-05	RESET ESTIMATED INFORMATION AND CONTROL INFORMATION OF DRIVE BATTERY CAPACITY	MSB-14EXML00_54-001C
2014-11-24	RESET ESTIMATED INFORMATION AND CONTROL INFORMATION OF DRIVE BATTERY CAPACITY	MSB-14EXML00_54-001D

RESET ESTIMATED INFORMATION AND CONTROL INFORMATION OF MAIN BATTERY CAPACITY

If replacing the main battery, reset the main battery capacity information and the control information.

note

If replacing the BMU and the main battery at the same time, you do not have to do this procedure.

1.Connect the M.U.T.-III to the diagnosis connector with the electric motor switch in the "LOCK" (OFF)position.
2.Turn the electric motor switch to the ON position.
3.From the System select Screen of the M.U.T.-III, select the "BMU".
4.Select the "Special Function" from the BMU Screen.
5.Select the "Reset" from the Special Function Screen
6.Select the "Battery capacity estimated info" from the Reset Screen, and reset.
7.After the estimated information of the main battery capacity is reset, select "Control information" from the Reset Screen to reset.
8.Turn the electric motor switch to the "LOCK" (OFF) position to disconnect the M.U.T.-III.

MMC-Manuals.ru