REMOVAL AND INSTALLATION

Pre-removal operation

Coolant Draining (Refer to .)
Front side member cover A and front wheel house cover removal (Refer to GROUP 51 - Under Cover .)
Front bumper core removal (Refer to GROUP 51 - Front Bumper Assembly .)
Headlamp assembly removal (Refer to GROUP 54A - Headlamp .)
Horn removal (Refer to GROUP 54A - Horn .)
Hood latch removal (Refer to GROUP 42 - Hood .)
Heater Piping Hose B Clip Connection Removal (Refer to GROUP 55 - Heater Hose ) <Vehicles for cold districts>

Post-installation operation

Heater Piping Hose B Clip Connection Installation (Refer to GROUP 55 - Heater Hose ) <Vehicles for cold districts>
Hood latch installation (Refer to GROUP 42 - Hood .)
Horn installation (Refer to GROUP 54A - Horn .)
Headlamp assembly installation (Refer to GROUP 54A - Headlamp .)
Front bumper core installation (Refer to GROUP 51 - Front Bumper Assembly .)
Front side member cover A and front wheel house cover installation (Refer to GROUP 51 - Under Cover .)
Coolant refilling (Refer to .)

			Removal steps
		1.	Ambient temperature sensor
		2.	Air guide panel
<<A>>	>>A<<	3.	Radiator lower hose
<<A>>	>>A<<	4.	Radiator upper hose
		5	Radiator bracket
		6.	Radiator bracket RH
		7.	Radiator bracket LH
<<B>>		·	Condenser assembly (Refer to GROUP 55 - Condenser Assembly .)
		8.	Cooling module

REMOVAL SERVICE POINTS

<<A>> RADIATOR HOSE DISCONNECTION

Because the hose and hose clip will be assembled back to original positions, make the mating mark as shown in the figure, and then perform the removal.

<<B>> CONDENSER ASSEMBLY REMOVAL

1.With the hoses and pipes still connected, remove the condenser assembly from the cooling module.
2.Tie the removed condenser assembly with a string at a position where it will not interfere with the removal and installation of cooling module.

INSTALLATION SERVICE POINTS

>>A<< RADIATOR HOSE CONNECTION

1.Insert the hose until the protrusion of each pipe.

2.Do not twist the hose. Align the mating marks of hose and hose clip, and then assemble.

MMC-Manuals.ru