)
|
1.Remove the filler plug and gasket. |
) |
2.Check that the oil level is in the range between the upper limit (filler plug hole lower
end) and lower limit as shown in the figure. 3.Check that the oil is not excessively foul and has moderate viscosity. 4.If the oil level is not in between the upper limit and the lower limit, refill the specified gear oil to the bottom of the oil filler plug hole. Brand name: Mitsubishi genuine Dia-Queen ATF SP III 5.Install a new gasket to the oil filler plug, and then tighten the plug to the specified torque. Tightening torque: 32 ± 2 N·m |
