DISASSEMBLY AND ASSEMBLY <LH DRIVE SHAFT>

caution

Because the vehicle speed detection encoder is magnetised, deposition of metal objects are prone to occur.Pay attention that no foreign objects are found on the vehicle speed detection encoder. At the same time, do not fail to check that no abnormality exists when assembling. In addition, always keep magnetic substances away from the magnetic encoder.
At disassembly and assembly, make sure that the vehicle speed detection encoder does not contact with surrounding parts to avoid damage.
With the EUJ assembly, only the EUJ boot is replaceable. Other parts cannot be disassembled.

			Disassembly steps
	>>B<<	1.	ETJ boot band (large)
	>>B<<	2.	ETJ boot band (small)
<<A>>	>>A<<	3.	ETJ case
		4.	Circlip
		5.	Snap ring
<<A>>	>>A<<	6.	Spider assembly
<<B>>		7.	ETJ boot
		8.	EUJ boot band (large)
		9.	EUJ boot band (small)
		10.	EUJ boot
		11.	EUJ assembly

GREASE APPLICATION AREA <LH DRIVE SHAFT>

DISASSEMBLY SERVICE POINT

<<A>> ETJ CASE AND SPIDER ASSEMBLY REMOVAL

caution

Do not disassemble the spider assembly.

1.Wipe off the grease inside the ETJ case and on the spider assembly.

2.If the grease is contaminated with the foreign material (water, dust, etc.), be sure to wash the spider assembly.

<<B>> ETJ BOOT REMOVAL

1.Wipe off the grease on the shaft spline.

2.If the ETJ boot is reused, protect the shaft spline area with taping from the damage in removal of the boot.

ASSEMBLY SERVICE POINT

>>A<< SPIDER ASSEMBLY AND ETJ CASE INSTALLATION

caution

Special grease is used for the joint. Do not mix the new and previous types of grease or different types of grease.

Fill the ETJ case with the specified grease, insert the drive shaft, and then fill the specified grease again.
Specified grease: Repair kit grease
Application amount: 95 ± 10 g

note

When using the repair kit grease, fill the half of the grease into the joint and the other half into the boot as a guideline, and consume the grease completely.

>>B<< ETJ BOOT BAND (SMALL) AND ETJ BOOT BAND (LARGE) TIGHTENING

Adjust the distance between the boot bands to the standard value to adjust the air volume inside the ETJ boot to the specified value, then be sure to tighten the ETJ boot band (large) and ETJ boot band (small).
Standard value (A): 80 ± 3 mm

MMC-Manuals.ru