DISASSEMBLY AND ASSEMBLY <RH DRIVE SHAFT>

caution

Because the vehicle speed detection encoder is magnetised, deposition of metal objects are prone to occur.Pay attention that no foreign objects are found on the vehicle speed detection encoder. At the same time, do not fail to check that no abnormality exists when assembling. In addition, always keep magnetic substances away from the magnetic encoder.
At disassembly and assembly, make sure that the vehicle speed detection encoder does not contact with surrounding parts to avoid damage.
With the EUJ assembly, only the EUJ boot is replaceable. Other parts cannot be disassembled.

			Disassembly steps
	>>B<<	1.	EDJ boot band (large)
	>>B<<	2.	EDJ boot band (small)
		3.	Circlip
		4.	EDJ outer race
		5.	Snap ring
		6.	Inner race, cage and ball assembly
<<A>>	>>A<<	7.	EDJ boot
		8.	EUJ boot band (large)
		9.	EUJ boot band (small)
		10.	EUJ boot
		11.	EUJ assembly

GREASE APPLICATION AREA <RH DRIVE SHAFT>

DISASSEMBLY SERVICE POINT

<<A>> EDJ BOOT REMOVAL

1.Wipe off the grease on the shaft spline.

2.If the EDJ boot is reused, wrap the shaft spline with adhesive tape to avoid damage during the removal of the boot.

ASSEMBLY SERVICE POINT

>>A<< EDJ BOOT INSTALLATION

Wrap the shaft spline with tape, and then assemble the boot.

>>B<< EDJ BOOT BAND (SMALL) AND EDJ BOOT BAND (LARGE) TIGHTENING

1.Adjust the distance between the boot bands to the standard value so as to adjust the air volume inside the EDJ boot to the specified value, then tighten the EDJ boot band (large) and EDJ boot band (small) securely.
Standard value (A): 85 ± 3 mm

MMC-Manuals.ru