REMOVAL AND INSTALLATION

caution

The part indicated by ^* indicates parts which should be temporarily tightened, and then fully tightened with the vehicle standing on the ground and the curb weight condition.

Post-installation operation

Headlamp aiming check (Refer to GROUP 54A - On-vehicle Service, Headlamp Aiming Adjustment .)

		REMOVAL AND INSTALLATION
	1.	Lateral rod assembly and height sensor connection
	2.	Lateral rod assembly
	3.	Clamp for rear parking brake cable and rear wheel speed sensor bracket
	4.	Shock absorber
	5.	Coil spring
	6.	Upper spring pad
	7.	Coil spring lower pad
	8.	Clamp for rear wheel speed sensor
	9.	Brake hose joining
	·	Drive shaft (Refer to Drive Shaft Removal and Installation .)
<<A>>	10.	Rear hub assembly
	11.	Axle assembly

REMOVAL SERVICE POINTS

<<A>> REAR HUB ASSEMBLY REMOVAL

Fix the rear hub assembly with a rope as shown in the figure.

MMC-Manuals.ru