|
Before disposing of the shock absorber, place it on a level surface with the shock absorber
extended, and punch a hole of approximately 3 mm in diameter at the position shown in the figure
to discharge the gas.
|
|
Set the following special tools as shown in the figure. Compress the coil spring, and
lower the axle assembly within a distance not more than 60 mm from the centre of shock absorber
lower side mounting section, and then remove the upper spring pad and coil spring.
- Spring compressor body (MB991237)
- Arm set (MB991239)
|
|
Install the coil spring with its end face aligned with the stepped shape of the axle assembly.
Alternatively, install the coil spring so that its end face is placed in the area shown in the figure.
|
.))
)
)
)
)
