|
|
Brake fluid: DOT3 or DOT4
|
|
|
Because a master cylinder without check valve is adopted, the air bleeding of brake pipe
line becomes easier when the master cylinder air bleeding is performed as described below. (When
no brake fluid is in the master cylinder)
|
|
|
1.Fill the brake fluid reservoir with the brake fluid.
|
|
|
2.Depress and hold the brake pedal.
|
|
3.Another operator closes the master cylinder outlets with his fingers.
4.In this condition, release the brake pedal.
5.Repeat Steps 2 to 4 for 3 or 4 times to fill the master cylinder with the brake fluid.
|
|
Perform the bleeding in the order shown in the figure.
|
)
)
)
)
