MSB is released for this page as follows:

Release Date	Subject	MSB No.
2011-09-20	i-MiEV TECHNICAL INFORMATION MANUAL AND WORKSHOP MANUAL	MSB-11E00-506A

DISASSEMBLY AND REASSEMBLY

		Disassembly steps
	1.	Bleeder cap
	2.	Bleeder
	3.	Pin bolt
	4.	Caliper support
	5.	Shim
	6.	Brake pad assembly
	7.	Clip
	8.	Pin
	9.	Pin boot
	10.	Pin
	11.	Pin bush
	12.	Pin boot
<<A>>	13.	Piston boot
<<A>>	14.	Piston
<<B>>	15.	Piston seal
	16.	Caliper body

note

Install the brake pad assembly (with wear indicator) to the inner side of the brake disc, making sure that the wear indicator is located on the top.

LUBRICATION POINTS

DISASSEMBLY SERVICE POINTS

<<A>> PISTON BOOT/PISTON REMOVAL

caution

Blow air gradually to remove the pistons. The pistons will rush out if a force of air is applied suddenly.

Cover the caliper body outer side with a cloth or similar materials. Blow compressed air through the brake hose installation area to remove the piston and piston boot.

<<B>> PISTON SEAL REMOVAL

caution

Do not use a flat-tipped screwdriver to remove the piston seal. This may damage the inner side of the cylinder.

Remove the piston seal with your finger tip.
2.Clean the piston surface and cylinder inner face with alcohol or specified brake fluid.
Brake fluid: DOT3 or DOT4

MMC-Manuals.ru