Code No. C1366
Lateral G sensor signal malfunction
caution
If there is
any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis,
diagnose the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
Whenever ECU is replaced, ensure that the CAN bus lines are normal.
OPERATION
The G and yaw rate sensor output signal is sent to ASC-ECU via the CAN bus lines.
DIAGNOSIS CODE SET CONDITIONS
ASC-ECU compares the wheel speed sensor and steering wheel sensor output signals with
the G and yaw rate sensor output signals. If it determines that the G and yaw rate sensor (lateral
G) output signal is not proper, it judges that a malfunction has occurred and sets the diagnosis
code.
PROBABLE CAUSES
Malfunction of the G and yaw rate sensor
G and yaw rate sensor improper installation
Malfunction of ASC-ECU
note
This diagnosis code may be set in the case of driving under special conditions such as
rough roads.
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 3.
Repair the CAN bus lines. (Refer to GROUP 54C - CAN Bus Diagnostics Table .)
On completion, go to Step 2.
STEP 2. Diagnosis code recheck after resetting CAN bus lines
Q.
Is the diagnosis code No.C1366 set?
Go to Step 3.
This diagnosis is complete.
STEP 3. G and yaw rate sensor installation state check
Check that the G and yaw rate sensor is installed correctly.
Q.
Is the check result normal?
Go to Step 4.
Reinstall the G and yaw rate sensor (Refer to ).
Then go to Step 6.
STEP 4. M.U.T.-III data list
Check the following data list (Refer to ).
Item No. 14: Lateral G sensor
Q.
Is the check result normal?
Go to Step 5.
Replace the G and yaw rate sensor (Refer to ).
Then go to Step 6.
STEP 5. Diagnosis code recheck
(1)Electric motor switch: "ON"
(2)Erase the diagnosis code.
(3)Electric motor switch: "LOCK" (OFF)
(4)Start the electric motor unit.
(5)Drive the vehicle at 40 km/h or more.
Q.
Is the diagnosis code No.C1366 set?
Replace the hydraulic unit (integrated with ASC-ECU) (Refer to ).
Then go to Step 6.
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/How
to Cope with Intermittent Malfunctions ).
Go to Step 3.
Repair the CAN bus lines. (Refer to GROUP 54C - CAN Bus Diagnostics Table 
.)
On completion, go to Step 2.