MSB is released for this page as follows:

Release Date	Subject	MSB No.
2014-12-15	The grommet clip for fixing the rear wheel sensor has been added for improving the reliability of the vehicle.	MSB-14E35-001

REMOVAL AND INSTALLATION

caution

The vehicle speed detection encoder collects any metallic particle easily, because it is magnetised. Make sure that the encoder should not collect any metallic particle. Check that there is not any trouble prior to reassembling it.

<Front>

<Rear>

		Front wheel speed sensor removal steps
	1.	Bolt (front wheel speed sensor and knuckle connection)
	2.	Front wheel speed sensor connector
<<A>>	3.	Front wheel speed sensor
		Rear wheel speed sensor removal steps
	4.	Bolt (rear wheel speed sensor and rear axle assembly connection)
	5.	Rear wheel speed sensor connector
<<A>>	6.	Rear wheel speed sensor

note

The wheel speed detection encoder is integrated with the front wheel bearing and the driveshaft assembly, which cannot be disassembled.

REMOVAL SERVICE POINTS

<<A>> FRONT WHEEL SPEED SENSOR/REAR WHEEL SPEED SENSOR REMOVAL

Remove the sensor by sliding the front/rear wheel speed sensor connector while pressing the lever of the connector shown in the figure to the direction of the arrow.

MMC-Manuals.ru