| caution |
- Be sure to remove the
clock spring from the column switch and centre the clock spring to prevent the damage of steering
wheel sensor.
- If the centre of the clock spring is not correctly aligned, the steering wheel may
not be turned fully or the cable inside the clock spring may be broken, causing the SRS air
bag to be inoperative or operated incorrectly.
- Before removing the steering wheel/air bag module assembly, refer to GROUP
52B - Service Precautions
 and Air Bag Module
and Clock Spring .
- When the steering wheel sensor is replaced or installed, always carry out calibration to
make ASC-ECU learn the neutral point (Refer to ).
- After adjusting the wheel alignment, always carry out calibration of the steering wheel
sensor to make ASC-ECU learn the neutral point. (Refer to ).
|
)
