REMOVAL AND INSTALLATION


danger When servicing the high voltage system parts, always wear the specified protective gears, and shut off the high voltage by removing the service plug (refer to GROUP 54D - Precautions for Handling High Voltage Vehicles ).
Pre-removal operationFloor console removal (Refer to GROUP 52A - Floor Console Assembly .)
 Post-installation operation
  • Parking brake lever stroke adjustment (Refer to .)
  • Floor console installation (Refer to GROUP 52A - Floor Console Assembly .)




Parking brake front cable removal steps


·
 Release the parking brake lever.


1.
 Adjusting nut


2.
 Parking brake lever assembly (Refer to .)


3.
 Parking brake front cable



Parking brake rear cable removal steps


·
 Rear drum brake (Refer to GROUP 35A - Rear Drum Brake .)


·
 Main battery assembly (Refer to GROUP 54D - Main Battery .)

>>A<<
 4.
 Parking brake rear cable connection


5.
 Clamp for rear wheel speed sensor


6.
 Parking brake rear cable

INSTALLATION SERVICE POINTS

>>A<< PARKING BRAKE REAR CABLE INSTALLATION
caution Check that the equaliser and the parking brake rear cable are connected correctly. If the parking brake is applied with the equaliser and the parking brake rear cable connected improperly, the equaliser may be damaged.

Connect the parking brake rear cable to the equaliser as shown in the figure.




Yandex.Metrika
MMC-Manuals.ru