)
- Specified grease: Multipurpose grease SAE J310, NLGI No.2 or equivalent
Usage: Tie rod end ball joint dust cover inside and lip section: Adequate
3.Using your fingers, press the dust cover to check for any crack or damage.
| Only when the dust cover is damaged during maintenance, replace the dust cover according to the steps below. |
|
1.Fill and apply the specified grease to the inside and lip of the dust cover, respectively.
Usage: Tie rod end ball joint dust cover inside and lip section: Adequate 3.Using your fingers, press the dust cover to check for any crack or damage. |
