MSB is released for this page as follows:

Release Date	Subject	MSB No.
2011-06-20	DOOR-SIDE DOOR HINGE MOUNTING BOLTS TIGHTENING TORQUES	MSB-11E42-501

REMOVAL AND INSTALLATION

Post-installation operation

Door adjustment (Refer to .)

			Door assembly removal steps
		·	Front scuff plate, cowl side trim (Refer to GROUP 52A - Interior Trim .)
		1.	Wiring harness connector connection
		2.	Door check connecting bolt
		3.	Door assembly
			Front door hinge removal steps
		·	Splash shield front (Refer to GROUP 42 - Splash Shield .)
		4.	Front door upper hinge
		5.	Front door lower hinge
			Damper removal
		6.	Damper
			Striker removal
	>>A<<	7.	Striker
			DOOR SWITCH REMOVAL STEPS
		·	Centre pillar trim lower (Refer to GROUP 52A - Interior Trim .)
		8.	Door switch

			Door assembly removal steps
		1.	Wiring harness connector connection
		2.	Door check connecting bolt
		3.	Door assembly
			Rear door hinge removal steps
		·	Centre pillar trim (Refer to GROUP 52A - Interior Trim .)
		4.	Rear door upper hinge
		5.	Rear door lower hinge
			Damper removal
		6.	Damper
			Striker removal
	>>A<<	7.	Striker
			Door switch removal
		8.	Door switch

INSTALLATION SERVICE POINTS

>>A<< STRIKER INSTALLATION

Install the striker so that the striker centre does not deviate more than ±1.5 mm from the latch centre.