.)
ADJUSTMENT OF ENGAGEMENT BETWEEN STRIKER AND LATCH |
| 1.Remove the rear end trim. (Refer to GROUP 52A -
Interior Trim .) |
) |
2.Install a temporary bolt instead of the striker mounting bolt, and use the remover bar (special tool: MB990939) and a hammer to tap the temporary bolt to the desired direction. 3.Tighten the striker mounting screws. Tightening torque: 20 ± 5 N·m 4.Install the rear end trim. (Refer to GROUP 52A - Interior Trim .) |
ADJUSTMENT OF CLEARANCE BETWEEN TAILGATE AND BODY |
) |
Loosen the tailgate-side tailgate hinge mounting bolts to adjust it. Tightening torque: 9.5 ± 2.5 N·m |
