REMOVAL AND INSTALLATION



caution
  • Do not disassemble or throw the tailgate gas spring into the fire.
  • Before disposal, make a hole to remove the gas.
  • Make sure that the piston rod should not collect any foreign particles.
Pre-removal operation
  • Tailgate spoiler assembly removal (Refer to GROUP 51 - Tailgate Spoiler .)
  • Tailgate trim assembly removal (Refer to GROUP 52A - Tailgate Trim .)
  • Rear wiper motor removal (Refer to GROUP 51 - Rear Wiper and Washer .)

Post-installation operation
  • Tailgate alignment (Refer to .)
  • Tailgate height adjustment (Refer to .)
  • Rear wiper motor installation (Refer to GROUP 51 - Rear Wiper and Washer .)
  • Tailgate trim assembly installation (Refer to GROUP 52A - Tailgate Trim .)
  • Tailgate spoiler assembly installation (Refer to GROUP 51 - Tailgate Spoiler .)






Damper removal


1.
Damper



Tailgate assembly removal steps


2.
Harness connector
<<A>>

3.
Tailgate gas spring


4.
Ball joint


5.
Tailgate assembly


·
Headlining assembly (Refer to GROUP 52A - Headlining .)


6.
Packing <two-tone paint>


7.
Tailgate hinge



Tailgate opening weatherstrip removal

>>A<<
8.
Tailgate opening weatherstrip

REMOVAL SERVICE POINTS



<<A>> TAILGATE GAS SPRING REMOVAL



Move the pin as shown, and move the gas spring to the direction indicated by the arrow to remove it.

INSTALLATION SERVICE POINTS



>>A<< TAILGATE OPENING WEATHERSTRIP INSTALLATION



The marking on the tailgate opening weatherstrip should be positioned at the centre of the vehicle.





Yandex.Metrika
MMC-Manuals.ru