MSB is released for this page as follows:

Release Date	Subject	MSB No.
2019-09-04	Addition of the descriptions about the Bolt to fix Tailgate Latch assembly due to change the Bolt type	MSB-19E42-001

REMOVAL AND INSTALLATION

Post-installation operation

		Pull handle removal steps
	1.	Pull handle
		Striker removal steps
	·	Rear end trim (Refer to GROUP 52A - Interior Trim .)
>>A<<	2.	Striker
		Tailgate lock release handle removal steps
	·	Tailgate trim (Refer to GROUP 52A - Tailgate Trim .)
	3.	Tailgate lock release handle
		Tailgate latch removal steps
	·	Tailgate trim (Refer to GROUP 52A - Tailgate Trim .)
	4.	Earth bolt
	5.	Tailgate latch assembly

INSTALLATION SERVICE POINTS

Install the striker so that the striker centre does not deviate more than ±1.5 mm from the latch centre.