Inspection Procedure 2: Keyless entry hazard lamp answerback function or the room lamp answerback function does not work normally.

caution

Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.

COMMENTS ON TROUBLE SYMPTOM

If the hazard warning lamp and the room lamp work normally, the ETACS-ECU may be defective.

Alternatively, it is possible that the keyless entry hazard lamp answerback function was disabled by the customise function.

PROBABLE CAUSES

Defective hazard warning lamp
Malfunction of the room lamp
Malfunction of the ETACS-ECU
Damaged harness wires and connectors

DIAGNOSIS PROCEDURE

STEP 1. Check the operation of the hazard warning lamp.

Check that the hazard warning lamp illuminates normally.

Q. Is the check result normal?

	Go to Step 2.

	Refer to GROUP 54A, Inspection Procedure 1 "The hazard warning lamp do not illuminate ".

STEP 2. Check the operation of the room lamp.

Check that the room lamp illuminates normally.

Q. Is the check result normal?

	Go to Step 3.

	Refer to GROUP 54A, Check Chart for Trouble Symptoms .

STEP 3. Check the operation of the keyless entry system.

If the keyless entry system is operated, check that the doors can be locked and unlocked normally.

Q. Is the check result normal?

	Go to Step 4.

	Refer to Trouble symptom chart .

STEP 4. Check the customisation function.

Using the customisation function, check that the number of flashings of hazard warning lamp is set to any of the followings other than "LOCK: 0/UNLOCK: 0."

Lock 1 Unlock 2
Lock 1 Unlock 0
Lock 0 Unlock 2
Lock 2 Unlock 1
Lock 0 Unlock 1
Lock 2 Unlock 0

Q. Is the check result normal?

	Go to Step 5.

	Enable the keyless entry hazard lamp answerback function by using the customisation function (Refer to ).

STEP 5. Retest the system.

Check that the keyless entry hazard lamp answerback function or the room lamp answerback function works normally.

Q. Is the check result normal?

	The trouble can be an intermittent malfunction (Refer to GROUP 00, How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).

	Replace the ETACS-ECU and register the ID codes (Refer to GROUP 54A, Encrypted Code Registration Criteria Table ).

MMC-Manuals.ru