REMOVAL AND INSTALLATION

		Door mirror assembly removal steps
	·	Front door trim (Refer to GROUP 52A, Door Trim .)
	·	Door mirror connector connection
	1.	Front door sash trim
	2.	Door mirror assembly
	5.	Clip
		Mirror removal
<<A>>	3.	Mirror
		Door mirror outer cover removal steps
<<A>>	3.	Mirror
<<B>>	4.	Door mirror outer cover
		Remote controlled mirror switch removal steps
	·	Switch panel undercover (Refer to group 52A, Instrument panel assembly .)
	6.	Remote controlled mirror switch

REMOVAL SERVICE POINTS

<<A>> MIRROR REMOVAL

caution

Claws of the mirror are prone to breakage when working in cold temperatures. Always use a hair drier or the like to warm up the claws and their periphery to 20°C or higher prior to works. When the mirror is heated too quickly from its cold state, it may be broken.

1.Push the upper side of the mirror with your finger to pull out the lower side of the mirror, then insert the flat-tipped screwdriver covered with a protective tape from the backside of the mirror. Insert the screwdriver in between the pivot plate and mirror, and pry off the mirror claw and release the lower side of the mirror.
2.Pull out the lower side of the mirror, and release the the upper side lock.

<<B>> DOOR MIRROR OUTER COVER REMOVAL

1.Remove the mirror (Refer to the step A of the REMOVAL SERVICE POINTS).
2.Disengage four claws at the door mirror outer cover from the door mirror assembly.
3.Lift the door mirror outer cover and remove it.

MMC-Manuals.ru