MSB is released for this page as follows:

Release Date	Subject	MSB No.
2016-10-18	Changes of the maintenance points for the under cover due to the market measures for the prevention of corrosion of the battery frame	MSB-16EXL51-004A
2016-06-29	Changes of the maintenance points for the under cover due to the market measures for the prevention of corrosion of the battery frame	MSB-16EXL54-004

REMOVAL AND INSTALLATION

Pre-removal and post-installation operation

Front wheelhouse cover extension removal and installation (Refer to GROUP 42, Splash Shield .)

			Removal steps
		1.	Front side member cover A
		·	Front tyre
		2.	Front wheelhouse cover
		3.	Floor plug
		4.	Bolt
		5	Front floor cover A
		6.	Floor plug
		7.	Bolt
		8.	Front floor cover B
<<A>>	>>A<<	9.	Rivet
		10.	Front side member cover B

DISASSEMBLY SERVICE POINT

<<A>> RIVETS REMOVAL

Use a drill (Φ 4.0 mm) to make a hole in the rivet to break it, and remove the rivet.

REASSEMBLY SERVICE POINT

>>A<< RIVETS INSTALLATION

Use a rivet tool shown as in the illustration to connect the parts with rivets by the following procedures:
1.Insert the rivet into a corresponding location.
2.Set the rivet tool at a portion A of rivet.
3.While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool.
4.Thin part of portion A of the rivet will be cut off and the parts is fixed in position.

MMC-Manuals.ru