)
| caution | If a dent, crack, deformation or rust is found, replace the sensor with a new front impact
sensor. |
2.Binding of wiring harness, damaged connector and deformation of terminal.
|
1.
2.Binding of wiring harness, damaged connector and deformation of terminal. |
) |
3.Measure the resistance between the front impact sensor terminals. OK: 820 ± 82 Ω |
) |
4.Check for continuity between each front impact sensor terminal and the bracket. OK : No continuity 5.Check the front impact sensor mounting area for deformation and rusting. Repair any deformation or other failure if any. |
