INDIVIDUAL COMPONENT SERVICE

caution

If the influence of heat is suspected during painting work, remove the following parts:

93°C or higher: SRS-ECU, air bag module, clock spring, front impact sensor, side impact sensor, rear detect sensor and passenger’s air bag cut off switch
90 °C or higher: Seat belt with pre-tensioner

If the SRS components are removed for the purpose of check, sheet metal repair, painting, etc., they should be stored in a clean, dry place until they are reinstalled.

If the SRS components are to be removed or replaced as a result of maintenance, troubleshooting etc., follow the service procedures that follow.

Front impact sensors; refer to
SRS-ECU; refer to
Driver’s air bag modules and clock spring; refer to
Passenger’s (front) air bag module; refer to
Side-airbag module; refer to
Curtain air bag module; refer to
Side impact sensors; refer to
Rear detect sensor; refer to
Seat belt with pre-tensioner; refer to