INSPECTION


caution
  • Never measure circuit resistance in the air bag modules (squib) even with the specified tester. Measuring the circuit resistance with a tester causes accidental air bag deployment due to current that flows or static, resulting in serious personal injury.
  • When replacing the parts, discard the old parts after deploying the air bag according to the specified procedure (Refer to ).
If any malfunction is found in the following inspections, replace the air bag module with a new one.


  1. Check the harness and connector for damage and the terminal for deformation.
  2. Check the air bag inflator cases for dents, cracks or deformation.
  3. Check the air bag module for proper installation.




Yandex.Metrika
MMC-Manuals.ru