REMOVAL AND INSTALLATION

caution

If the combination meter needs to be replaced, the current driving distance and elapsed days must be entered into the meter after the replacement in order to be used for service reminder function. Therefore, read "Integrated mileage for reminder," "Integrated days for reminder," "Mileage until Extra reminder," "Months until Extra reminder," and "Current schedule" from the meter before the replacement using the special function of M.U.T.-III, and note them. For the operation method of M.U.T.-III, refer to On-vehicle service . If "Integrated mileage for reminder" or "Integrated days for reminder" cannot be read from the meter using M.U.T.-III, use the following method. As for the driving distance for check warning, use the driving distance displayed on the odometer. As for the elapsed days for check warning, calculate the number of elapsed days from the delivery date to the customer (service reminder function start date) and current date.

Removal steps · Steering column upper cover (Refer to GROUP 52A - Instrument Panel Assembly .) 1. Meter bezel · Combination meter assembly connector <<A>> >>A<< 2. Combination meter assembly

1.Slide the combination meter assembly towards the steering wheel as shown, and then turn the steering wheel anticlockwise.

2.Pull out the combination meter assembly from the steering wheel.

1.Set the steering wheel as shown to engage the combination meter into the steering wheel opening.

2.Turn the steering wheel clockwise while holding the combination meter, and then install the combination meter assembly to the instrument panel.

---

MMC-Manuals.ru