AUDIO ERROR CODES

If the radio and CD player detects any malfunction in itself or the inserted CD, the error codes below will be shown on the display.

Error code	Cause	Cause of trouble and its solution
E	Power supply error Communication error Other error	This error code will be displayed if the internal error is detected in the radio and CD player. Replace the radio and CD player.
E 01	Focus error	These error codes will be shown if there is any problem with the CD or there is excessive vibration on the vehicle. If the error codes are not displayed when the vehicle is stopped and another CD is inserted, there is a problem with the CD. Check if there is any of the following problems with the CD. Contamination, scratch, or deformation Formation of moisture or grease If the error code does not disappear even when the normal CD is inserted, oil film or condensation may be generated inside the radio and CD player. Clean the inside of the radio and CD player, and check that no error codes are displayed.
E 02	Abnormal disc
E 03	Mechanical error	This error codes will be shown if there is any internal mechanical or electrical problem in the radio and CD player. Replace the radio and CD player check that no error codes are shown.
E HOT	Protection against high temperature	If the internal temperature is extremely high, this error code will be shown. Turn off the radio and CD player and wait until they cool down. Wait for a while, and then turn on the unit again. Check that the same error does not appear.