Code No. P1B0D: Quick charging current error (overcurrent)
caution
If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, always diagnose the CAN bus lines.
OPERATION
The quick charger communicates with EV-ECU via the local CAN (for the quick charger).
BMU communicates with EV-ECU via CAN.
DIAGNOSIS CODE SET CONDITIONS
If the battery current from the BMU is larger than the on board charger current command value by the specified value or more for 5 seconds or longer, the diagnosis code No. P1B0D will be set.
PROBABLE CAUSES
Malfunction of quick charger
Malfunction of the BMU
Malfunction of the EV-ECU
Malfunction of the main battery
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnosis
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 3.
Repair the CAN bus line. (Refer to GROUP 54C - Troubleshooting .) Then go to Step 2.
STEP 2. Diagnosis code recheck after resetting CAN bus lines
Check again if the diagnosis code No. P1B0D is set to the EV-ECU.
(1)Erase the stored diagnosis code.
(2)Set the electric motor switch from the LOCK (OFF) position to the ON position.
(3)Check if the diagnosis code is set.
Q.
Is the diagnosis code set?
Go to Step 3.
This diagnosis is complete.
STEP 3. Diagnosis code recheck
Check again if the diagnosis code is set to the EV-ECU.
(1)Erase the stored diagnosis code.
(2)Set the electric motor switch from the LOCK (OFF) position to the ON position.
(3)Check if the diagnosis code is set.
Q.
Is the diagnosis code set?
Check the quick charger. Then go to Step 4.
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction .)
STEP 4. Diagnosis code recheck
Check again if the diagnosis code is set to the EV-ECU.
(1)Erase the stored diagnosis code.
(2)Set the electric motor switch from the LOCK (OFF) position to the ON position.
(3)Check if the diagnosis code is set.
Q.
Is the diagnosis code set?
Replace the BMU. (Refer to .) Then go to Step 5.
The diagnosis is complete.
STEP 5. Diagnosis code recheck
Check again if the diagnosis code is set to the EV-ECU.
(1)Erase the stored diagnosis code.
(2)Set the electric motor switch from the LOCK (OFF) position to the ON position.
(3)Check if the diagnosis code is set.
Q.
Is the diagnosis code set?
Replace the EV-ECU. (Refer to .) Then go to Step 6.
The diagnosis is complete.
STEP 6. Diagnosis code recheck
Check again if the diagnosis code is set to the EV-ECU.
(1)Erase the stored diagnosis code.
(2)Set the electric motor switch from the LOCK (OFF) position to the ON position.
(3)Check if the diagnosis code is set.
Q.
Is the diagnosis code set?
Replace the main battery. (Refer to .) Then go to Step 7.
The diagnosis is complete.
STEP 7. Diagnosis code recheck
Check again if the diagnosis code is set to the EV-ECU.
(1)Erase the stored diagnosis code.
(2)Set the electric motor switch from the LOCK (OFF) position to the ON position.
Go to Step 3.
Repair the CAN bus line. (Refer to GROUP 54C - Troubleshooting 
.) Then go to Step 2.