Code No. P1B1C: ETACS lost (MCU)
| caution |
If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, always diagnose the CAN bus lines.
|
OPERATION
- MCU communicates with the EV-ECU via CAN.
DIAGNOSIS CODE SET CONDITIONS
- When the diagnosis code No. U1109 is set to the MCU, the diagnosis code No. P1B1C will be set.
PROBABLE CAUSES
- Malfunction of the MCU system
|
|
STEP 1. M.U.T.-III CAN bus diagnosis
|
|
|
Use the M.U.T.-III to diagnose the CAN bus lines.
|
|
|
Q.
Is the check result normal?
|
|
|
 Go to Step 3.
|
|
|
|
|
|
 Repair the CAN bus line. (Refer to GROUP 54C - Troubleshooting  .) Then go to Step 2.
|
|
|
|
|
|
STEP 2. Diagnosis code recheck after resetting CAN bus lines
|
|
|
Check again if the diagnosis code No. P1B1C is set to the EV-ECU.
|
|
|
(1)Erase the stored diagnosis code.
|
|
|
(2)Set the electric motor switch from the LOCK (OFF) position to the ON position.
|
|
|
(3)Check if the diagnosis code is set.
|
|
|
Q.
Is the diagnosis code set?
|
|
|
Go to Step 3.
|
|
|
|
|
|
This diagnosis is complete.
|
|
|
|
|
|
STEP 3. Use M.U.T.-III to confirm a diagnosis code of other systems.
|
|
|
Check if the diagnosis code No. U1109 is set to the MCU.
|
|
|
Q.
Is the diagnosis code set?
|
|
|
Carry out troubleshooting for the diagnosis code No. U1109. (Refer to .) Then go to Step 4.
|
|
|
|
|
|
Go to Step 4.
|
|
|
|
|
|
STEP 4. Diagnosis code recheck
|
|
|
Check again if the diagnosis code is set to the EV-ECU.
|
|
|
(1)Erase the stored diagnosis code.
|
|
|
(2)Set the electric motor switch from the LOCK (OFF) position to the ON position.
|
|
|
(3)Check if the diagnosis code is set.
|
|
|
Q.
Is the diagnosis code set?
|
|
|
Return to Step 1.
|
|
|
|
|
|
The diagnosis is complete.
|
|
|
|
MMC-Manuals.ru