Code No. U1910: K-line between MCUs reception error

ELECTRIC MOTOR UNIT CONTROL SYSTEM CIRCUIT

DIAGNOSIS CODE SET CONDITIONS

If the MCU detects either of an error related to reception of the K-LINE data from the EV-ECU or an error between the sum value and that in the data in the MCU 5 times consecutively, the diagnosis code No. U1910 will be set.

PROBABLE CAUSES

Malfunction of the K-LINE
Malfunction of the EV-ECU
Malfunction of the MCU

DIAGNOSIS PROCEDURE

STEP 1. M.U.T.-III CAN bus diagnosis

Use the M.U.T.-III to diagnose the CAN bus lines.

Q. Is the check result normal?

	Go to Step 3.

	Repair the CAN bus line. (Refer to GROUP 54C - Troubleshooting .) Then go to Step 2.

STEP 2. Diagnosis code recheck

Check again if the diagnosis code No. U1910 is set to the MCU.

(1)Erase the stored diagnosis code.

(2)Set the electric motor switch from the "LOCK" (OFF) position to the "ON" position.

(3)Check if the diagnosis code is set.

Q. Is the diagnosis code set?

	Go to Step 3.

	This diagnosis is complete.

STEP 3. Connector check: C-110 EV-ECU connector, E-06 MCU connector

Q. Is the check result normal?

	Go to Step 4.

	Repair the damaged connector.

STEP 4. Check the wiring harness between C-110 EV-ECU connector terminal No. 76 and E-06 MCU connector terminal No. 9.

Check the K-LINE for open circuit.

Q. Is the check result normal?

	Go to Step 5.

	Repair the wiring harness.

STEP 5. Diagnosis code recheck

Check again if the diagnosis code No. U1910 is set to the MCU.

(1)Erase the stored diagnosis code.

(2)Set the electric motor switch from the "LOCK" (OFF) position to the "ON" position.

(3)Check if the diagnosis code is set.

Q. Is the diagnosis code set?

	Replace the EV-ECU. (Refer to .) Then go to Step 6.

	Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction .)

STEP 6. Diagnosis code recheck

Check again if the diagnosis code is set to the MCU.

(1)Erase the stored diagnosis code.

(2)Set the electric motor switch from the "LOCK" (OFF) position to the "ON" position.

(3)Check if the diagnosis code is set.

Q. Is the diagnosis code set?

	Replace the MCU. (Refer to .) Then go to Step 7.

	The diagnosis is complete.

STEP 7. Diagnosis code recheck

Check again if the diagnosis code is set to the MCU.

(1)Erase the stored diagnosis code.

(2)Set the electric motor switch from the "LOCK" (OFF) position to the "ON" position.

(3)Check if the diagnosis code is set.

Q. Is any diagnosis code set?

	Go to Step 1.

	The diagnosis is complete.

MMC-Manuals.ru