MSB is released for this page as follows:

Release Date	Subject	MSB No.
2015-03-04	Addition of the brand "Ze-GLES RB68" of A/C compressor oil	MSB-15EXML55-001

REMOVAL AND INSTALLATION

Pre-removal and post-installation operation

Discharging and Recharging refrigerant (Refer to )
Front bumper face removal and installation (Refer to GROUP 51 - Front Bumper Assembly .)
Air guide panel removal and installation (Refer to GROUP 51 - Front Bumper Assembly .)

		Removal steps
<<A>>	1.	Stopper
<<B>>	2.	A/C condenser outlet pipe connection
<<B>>	3.	A/C condenser discharge hose
	4.	O-ring
	5.	Radiator support insulator
	6.	Condenser header cap
	7.	O-ring
	8.	Dryer
	9.	Condenser assembly

REMOVAL SERVICE POINTS

Remove it using a flat-tipped screwdriver as shown in the figure.

caution

Use the plug which is not breathable because A/C compressor oil or receiver have high hygroscopicity.
For the compressor oil and installation oil for the piping O-ring, use the oil MA68EV dedicated for the A/C compressor EV30AN3. If an oil other then the MA68EV is used, even if it is only a small amount, the electric insulation is considerably deteriorated and a leakage may occur.

Plug the removed nipple of the pipe, hose and condenser to prevent the entry of dust and dirt.