MSB is released for this page as follows:

Release Date	Subject	MSB No.
2015-03-04	Addition of the brand "Ze-GLES RB68" of A/C compressor oil	MSB-15EXML55-001

REMOVAL AND INSTALLATION

Pre-removal operation

Draining water heater fluid (Refer to .)
Discharging refrigerant (Refer to )
Instrument panel assembly removal (Refer to GROUP 52A - Instrumental Panel).
Cowl side trim removal (Refer to GROUP 52A - Interior trim .)
Removing front console (Refer to GROUP 52A - Floor Console Assembly .)
Front passenger's seat removal (Refer to GROUP 52A - Floor Console Assembly .)

Post-installation operation

Front passenger's seat installation (Refer to GROUP 52A - Floor Console Assembly .)
Installing front console (Refer to GROUP 52A - Floor Console Assembly .)
Cowl side trim installation (Refer to GROUP 52A - Interior trim .)
Instrument panel assembly installation (Refer to GROUP 52A - Instrumental Panel).
Filling up water heater fluid (Refer to .)
Charging refrigerant (Refer to )

			Removal steps
		1.	Heater air intake duct C
		2.	Heater air intake duct B
<<A>>		3.	A/C compressor suction hose
<<A>>		4.	A/C condensor outlet pipe
		5.	O-ring
		6.	Front floor console heater duct protector <Vehicles with quick charger>
		7.	Front floor console heater duct <Vehicles with quick charger>
		8.	Heater hose piping
		9.	Heater air intake duct A
		10.	Defroster nozzle
		11.	Heater assembly

REMOVAL SERVICE POINT

<<A>> A/C COMPRESSOR SUCTION HOSE AND A/C CONDENSOR OUTLET PIP DISCONNECTION

caution

Use the plug which is not breathable because A/C compressor oil or receiver have high hygroscopicity.
For the compressor oil and installation oil for the piping O-ring, use the oil MA68EV dedicated for the A/C compressor EV30AN3. If an oil other then the MA68EV is used, even if it is only a small amount, the electric insulation is considerably deteriorated and a leakage may occur.

Plug the removed nipple of the pipe, hose and expansion valve to prevent the entry of dust and dirt.