REMOVAL AND INSTALLATION

			Blower moter removal step
		1.	Blower motor
			Heater control transistor removal steps
		·	Glove box assembly (Refer to GROUP 52A , Instrument panel assembly )
		2.	Heater under cover
		3.	Heater control transitor

			Outside/inside air selection damper control motor and potentiommeter removal step
		·	Instrument panel assembly (Refer to GROUP 52A , Instrument panel assembly )
		4.	Outside/Inside air selection damper control motor and potentionmeter

<LHD>

<RHD>

			Mode selection damper control motor and potentionmeter removal step
		5.	Mode selection damper control motor and potentionmeter
			Air mixing damper control motor and potentionmeter removal step
		·	Under cover (Refer to GROUP 52A , Instrument panel assembly )
		6.	Heater pipe cover <LHD>
<<A>>		7.	Air mixing damper control motor and potentionmeter

			Foot area air outlet/main battery cooling selection damper motor removal step
		8.	Foot area air outlet/main battery cooling selection damper motor <Vehicles with quick charger>

REMOVAL SERVICE POINT

<<A>> AIR MIXING DAMPER CONTROL MOTOR AND POTENTION METER REMOVAL

note

A commercial plate type ratchet screwdriver is recommended.